Accufast Kt Tabber Manual
How do I adjust and clean the Accufast KT Tab Sensor? Published: December 3, 2011 UPDATED If you experience tabbing problems on the Accufast KT, tune the sensor for – Also know as a KT Sensor Reset: WARNING DO NOT PLACE FINGERS OR TOOLS BETWEEN OR NEAR MOVING PARTS. 1) Turn the POWER SWITCH off. 2) Remove any tabs and debris from the peel point area through the INSPECTION WINDOW on the input end, below the threading path. CAUTION IF ALL TABS AND DEBRIS ARE NOT REMOVED FROM THE PEEL POINT AREA BEFORE CLEAR TAB IS ACTIVATED, THE SENSOR’S DEFINITION OF CLEAR TABS WILL CHANGE AND CLEAR TABBING WILL BE PREVENTED. On the product entry side, there is an elongated hole under where the tabs peel off, see below If you look inside the hole, you will see the bottom portion of the sensor.
The Accufast KT2 Operators Manual includes Helpful Hints and Trouble. 6.4 Other Feeding Devices RENA T-600 IN-LINE DUAL TABBER Operating Manual.
(The black circle in the white plastic, see photo below) Clean it off with some. Also, make sure no tabs are anywhere in the path. If you remove the tabs and look from the exit side, you can see the top portion of the sensor. In the photo below, look for the rectangle with the nut on it. The sensor is on the bottom of the white housing directed down at the lower sensor.
Once you have this area clean turn the KT back on and, 3) Toggle CLEAR TAB off and wait, a few seconds 4) Toggle CLEAR TAB on. 5) Toggle ON/OFF until a tab advances to the peel point and the TAB READY light illuminates.Your sensor has now been re-calibrated!Another thing to check is to make sure the tabs are threaded correctly!
See photos below. Below Shows to correct way to thread the Accufast KT Tabber Correct Incorrect Do you need a KT? Give All For Mailers a call at 866-430-2874 New and Used Accufast KT available!
Prikoljnie banderoli na yubilej. The pebble beach in Big Scaraba bay with its pier is a favorite place for swimmers and divers.
Need Need Replacement Parts? SuppliesForMailers.com has them!
Need a parts breakdown / parts manual? Try Find the part, click on it and order! Need some help replacing the tab sweep? Check out Similar Posts: • Posted November 28, 2017 • Posted August 30, 2011 • Posted November 27, 2017 • Posted May 19, 2010 • Posted June 4, 2009.
New USPS Standards for Letter-Sized Booklets Effective September 8, 2009 'letter-sized booklets' as defined by the USPS require the use of 1.5' tabs to properly seal the open end of self-mailer booklets. Only properly tabbed or sealed booklets will be eligible for machineable or automation postal rates. Please refer to Postal Service Publication 39 CFR Part 111 New Standards for Letter-Sized Booklets for details. Introducing The Accufast KT-1.5.The 1.5' Tab Solution • applies 1 tab per piece • tabs 15,000 pieces per hour • tabs pieces 5' to 12' wide, from 20 lb.
Thin to 1/4' thick, coated and uncoated • runs a variety of 1 and 1.5 inch tabs: paper & clear, circles & rectangles, on rolls with or without tractor holes • built-in waste take-up spool 5,000 one inch and 4,000 1.5 inch tabs per roll. • weighs 47 pounds • measures 10'l x 17'h x 21'w • uses 115 volts 2 amps 60 hz or 230 volts 1 amp 50 hz • goes in-line with ACCUFAST and other table top Labelers, Feeders and Printers • its outstanding feature is its ability to run both 1 and 1.5 inch tabs at the flick of a switch. Learn more; contact Brett; Toll Free: 1-800-ETBRETT (382-7388), send us an email: brett@etbrett.com or visit our website: www.etbrett.com.